Storm Category 4 Solid Stain w/Enduradeck

Product Description

Storm System Acrylic Stain w/ Enduradeck Technology is a low sheen finish designed for use on decks and other exposed flat areas as well as vertical siding, fences and railings that are subjected to the rigors of drastic weather and temperature conditions, abrasion, acid rain or snow. This high hiding stain provides maximum protection against water, ultraviolet rays and general atmospheric contamination. This stain resists cracking, peeling and blistering and can be used on new wood, previously stained wood, properly pressure treated wood.

Recommended Use

Sundecks, railings and posts, fences, benches, trellis, wood walkways, open porches, wood screening, patios, garden enclosures, outdoor furniture, siding and composite decking.

Application

Surfaces must be thoroughly clean and dry. Always test a small area before application to the entire surface. All mildewed areas should be cleaned with Storm System All Surface Mold & Mildew Stain Remover. New pressure treated wood should be scrubbed with Storm System All Surface Cleaner to remove all surface deposits. Rinse thoroughly and allow to dry. All surfaces should be sanded down to remove any dead wood fibers from the surface, to ensure proper penetration and adhesion. If coating over a previous Semi-Transparent or Semi-Solid stain, sand surface down to bare wood. New Cedar or redwood siding may have Mill Glaze. Abrading the surface by sanding will ease the surface tension and allow for the stain to properly penetrate and adhere. Lead Warning ! - If you scrape, sand or remove old paint from any surface, you may release lead dust.

LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Carefully clean up with a wet mop or HEPA vacuum. Before you start, find out how to protect yourself and your family by contacting the U.S. EPA/Lead Information Hotline at 1-800-424-LEAD (5323) or log on to www.epa.gov/lead. Stir thoroughly before and during application to insure uniform appearance. Material should be intermixed by pouring into a large container and stirring before painting large areas, to insure color uniformity. On bare wood, thin the first coat with approximately one-pint water per gallon, then apply 1 or 2 un-thinned finish coats. Apply evenly with a quality nylon or synthetic brush maintaining a wet edge. Start at the end of boards and go along surfaces to a break point to avoid lapping. If spraying, back brush immediately. This product may also be applied by roller or pad applicator.

Coverage: 325-375 square feet per gallon on smooth surfaces. 200-275 square feet per gallon on porous surfaces.

Dry time: 1 hour to touch, 4 hours to recoat.